Log, Pushover

<< Click to Display Table of Contents >>

Navigation:  Using SyncBackPro > Expert Mode >

Log, Pushover

Previous pageReturn to chapter overviewNext page

 

Expert Mode: Log, Pushover

 

SyncBackSE and SyncBackPro can be configured to send a Pushover message if a profile run fails and/or succeeds. Pushover messages can be received on a wide range of devices, e.g. iOS, Android, macOS and Windows. A Pushover message is similar to an SMS but without the costs. To be able to use this feature you must create a Pushover account.

 

warning

Note: Pushover has strict limits on the number of messages that can be sent per month. Those limits apply globally to SyncBackSE and SyncBackPro and are reset at midnight (Central U.S.) on the first day of each month. If that limit is met then no more messages can be sent by anyone until the limit is reset.

 

We recommend that you create your own application token and use that. That way you can have your own limits which will be more than enough.

 

Send a Pushover message if the profile run fails: If enabled then a Pushover message is sent if the profile run fails.

 

Send a Pushover message if the profile run is a success: If enabled then a Pushover message is sent if the profile run is a success.

 

warning

A message will only be sent if the profile was not run manually and it was not a simulated run.

 

User/Group key: Enter your user key here, or optionally enter a group key for it to be sent to a group of people. To make sure the key, and device, are correct click the Verify button.

 

Device: This setting is optional. The default is to send the message to all the devices you have registered with the user/group key. You may choose to send the message to a specific device only. Click the Refresh button to populate the list.

 

Title: This setting is optional and is the title for the message. You can use variables, e.g. %PROFILENAME%. As the same title is sent on success or failure we recommend you use variables, e.g. %RUNRESULT%. The maximum length is 100 characters.

 

Message: This is the message to send. You can use variables, e.g. %PROFILENAME%. As the same message is sent on success or failure we recommend you use variables, e.g. %RUNRESULT%. The maximum length is 500 characters.

 

Use my own application token: This setting is optional, but we recommend that you create your own application token to avoid the message limits set by Pushover. If you use your own application token then you can use the Test button to make sure the settings are correct.

 

 

 

All Content: 2BrightSparks Pte Ltd © 2003-2017