For technical support visit http://support.2brightsparks.com/
3 posts • Page 1 of 1
- Posts: 2
- Joined: Thu Mar 30, 2006 11:21 pm
I'm using Pro V220.127.116.11 (x64). The result column indicates success or failure for ungrouped profiles, but remains blank for group profiles. I'd suggest it should also indicate the result for group profiles -- success if all the lower-order profiles have success, otherwise failure. At present, users have to expand all the groups and subgroups to see what has happened (even then, some profile results might have been recorded on earlier runs, so users may have to sift through quite a lot of dates too -- maybe the results from earlier runs could appear in a different font or shade, so that those of current interest are easier to spot). It would be far more convenient to expand the groups only when a failure has occurred. Then the table would normally be more compact and the results clear at a glance, expanding being needed only if any failure has occurred.
Who is online
Users browsing this forum: No registered users and 6 guests